How long does a 100Ah battery last with TV + set-top box + 2 fans + 3 lights?

The arithmetic, line by line

The evening serial does not stop for load shedding. Duty cycle matters here: Battery Buddy multiplies each appliance by the minutes it actually runs in an hour, so a fridge that cycles 40 minutes an hour is counted at two-thirds of its nameplate wattage instead of full blast.

Why a 100Ah battery only gives you 420Wh

On paper a 100Ah 12V battery stores 100 x 12 = 1200Wh. You never get that. Lead-acid tubular plates are rated for roughly 50% depth of discharge, and the inverter loses more converting DC to AC, so the honest figure is 100 x 12 x 0.7 x 0.5 = 420Wh.

Entry-level tubular sold for one-room and shop backup. If you have already measured your own system with the efficiency estimator, put your real factor into the calculator — that single number moves the answer more than any other input.

What this result means for your outage

At 1 hour 44 minutes this is a High Load setup — Battery Buddy flags anything under 2 hours, because a single long outage will empty the bank before the grid returns.

• Step up the bank: a 135Ah battery on the same load gives about 2 hours 21 minutes.
• Swap induction ceiling fans for 30W BLDC fans — that alone removes roughly 40W per fan.
• Move the heaviest appliance off the inverter circuit entirely rather than trying to out-size it.

Will the inverter actually hold this load?

Runtime and capacity are two different questions. With every appliance on at once this profile draws 242W continuous, which sizes to (242W / 0.8) x 1.25 on average draw and lands on a standard 600VA inverter.

The start-up surge test is the one most calculators skip. Ceiling Fan spikes to about 210W for a second or two when its motor kicks in, so peak demand is 242W continuous + 210W surge = 452W. Against a 600VA inverter that is 25% headroom — it holds.

Efficiency is the number that actually moves the answer

Battery age, electrolyte level, cable thickness and terminal corrosion all show up as one thing: a lower effective efficiency. Here is the same battery and the same load across the realistic range.

Run the two-hour test on the efficiency estimator to replace this guess with your own measured factor.

Other battery sizes against TV night

If you are still choosing a battery, this is the whole shelf against exactly this load.

Other loads on a 100Ah battery

And this is the same 100Ah battery against every other load profile we model.

Frequently asked questions

How long will a 100Ah battery last with TV + set-top box + 2 fans + 3 lights?

About 1 hour 44 minutes. The load averages 242W and the battery delivers 420Wh usable at 70% efficiency and 50% depth of discharge, so 420 / 242 = 1.7 hours.

Why does my 100Ah battery give less than 1.7 hours in practice?

Because 70% is an assumption, not your measurement. A battery two or three years old, a low electrolyte level, thin cabling or a charger that never completes a cycle in short grid windows all pull the effective factor down. At 55% the same setup gives 1 hour 22 minutes. Measure yours with the efficiency estimator.

What inverter size suits TV + set-top box + 2 fans + 3 lights?

A standard 600VA inverter. The sizing rule is (average load / power factor 0.8) x 1.25 safety margin, which on 242W gives 378VA and rounds up to the nearest retail tier.

Can I use the full 100Ah of the battery?

No. Lead-acid tubular batteries are rated for roughly 50% depth of discharge — draining past half state of charge sulphates the plates and shortens life sharply. That is why 100Ah x 12V = 1200Wh nominal becomes 420Wh usable.

How do I get more backup out of this setup without buying a bigger battery?

Cut the load, not the comfort. Replacing induction ceiling fans with 30W BLDC fans and any remaining CFLs with 9W LEDs typically removes 40-45W per fan and 6W per bulb. On this profile that is the difference between 1 hour 44 minutes and materially more, at a fraction of the cost of a second battery.

Does Battery Buddy sell batteries or recommend a brand?

No. Battery Buddy is a free, brand-neutral calculator from Flocci Technologies. It shows the formula for every number so you can check it against any dealer's quote, and it needs no sign-up.