Home / Backup time / 100Ah with WFH desk
A 100Ah 12V tubular battery runs Laptop + WiFi router + 1 fan + 2 lights for about 2 hours 35 minutes. That load averages 163W, and the battery holds 420Wh usable once you apply 70% inverter efficiency and the 50% depth of discharge lead-acid batteries are limited to. 420Wh / 163W = 2.6 hours.
A work-from-home desk that has to survive the outage without dropping a call. Duty cycle matters here: Battery Buddy multiplies each appliance by the minutes it actually runs in an hour, so a fridge that cycles 40 minutes an hour is counted at two-thirds of its nameplate wattage instead of full blast.
| Appliance | Watts each | Qty | Minutes per hour | Average draw |
|---|---|---|---|---|
| Laptop | 65W | 1 | 60 min | 65W |
| WiFi Router | 10W | 1 | 60 min | 10W |
| Ceiling Fan | 70W | 1 | 60 min | 70W |
| LED Bulb | 9W | 2 | 60 min | 18W |
| Total average hourly load | 163W |
On paper a 100Ah 12V battery stores 100 x 12 = 1200Wh. You never get that. Lead-acid tubular plates are rated for roughly 50% depth of discharge, and the inverter loses more converting DC to AC, so the honest figure is 100 x 12 x 0.7 x 0.5 = 420Wh.
Entry-level tubular sold for one-room and shop backup. If you have already measured your own system with the efficiency estimator, put your real factor into the calculator — that single number moves the answer more than any other input.
At 2 hours 35 minutes this is a Moderate Load setup — it clears the 2-hour danger line but stays under 5 hours, so a long monsoon outage will need you to shed something.
Runtime and capacity are two different questions. With every appliance on at once this profile draws 163W continuous, which sizes to (163W / 0.8) x 1.25 on average draw and lands on a standard 600VA inverter.
The start-up surge test is the one most calculators skip. Ceiling Fan spikes to about 105W for a second or two when its motor kicks in, so peak demand is 163W continuous + 105W surge = 268W. Against a 600VA inverter that is 55% headroom — it holds.
Battery age, electrolyte level, cable thickness and terminal corrosion all show up as one thing: a lower effective efficiency. Here is the same battery and the same load across the realistic range.
| System efficiency | Usable energy | Estimated backup |
|---|---|---|
| 55% | 330Wh | 2 hours 1 minutes |
| 60% | 360Wh | 2 hours 13 minutes |
| 65% | 390Wh | 2 hours 24 minutes |
| 70% (default) | 420Wh | 2 hours 35 minutes |
| 75% | 450Wh | 2 hours 46 minutes |
| 80% | 480Wh | 2 hours 57 minutes |
Run the two-hour test on the efficiency estimator to replace this guess with your own measured factor.
If you are still choosing a battery, this is the whole shelf against exactly this load.
| Battery | Usable energy | Estimated backup | Band |
|---|---|---|---|
| 100Ah (this page) | 420Wh | 2 hours 35 minutes | Moderate |
| 120Ah | 504Wh | 3 hours 6 minutes | Moderate |
| 135Ah | 567Wh | 3 hours 29 minutes | Moderate |
| 150Ah | 630Wh | 3 hours 52 minutes | Moderate |
| 165Ah | 693Wh | 4 hours 15 minutes | Moderate |
| 180Ah | 756Wh | 4 hours 38 minutes | Moderate |
| 200Ah | 840Wh | 5 hours 9 minutes | Low load |
| 220Ah | 924Wh | 5 hours 40 minutes | Low load |
| 250Ah | 1050Wh | 6 hours 27 minutes | Low load |
And this is the same 100Ah battery against every other load profile we model.
| Load profile | Average draw | Estimated backup |
|---|---|---|
| 2 ceiling fans + 3 LED bulbs | 167W | 2 hours 31 minutes |
| 1 ceiling fan + 2 LED bulbs | 88W | 4 hours 46 minutes |
| 3 ceiling fans + 5 LED bulbs | 255W | 1 hour 39 minutes |
| 2 fans + 4 lights + TV + WiFi router | 246W | 1 hour 42 minutes |
| Refrigerator + 2 fans + 4 LED bulbs | 276W | 1 hour 31 minutes |
| Laptop + WiFi router + 1 fan + 2 lights (this page) | 163W | 2 hours 35 minutes |
| 2 fans + 6 lights + TV + refrigerator + WiFi | 404W | 1 hour 2 minutes |
| Air cooler + 2 LED bulbs | 198W | 2 hours 7 minutes |
| 4 tube lights + 2 fans + billing computer | 420W | 1 hour |
| 1 fan + 2 lights + 2 mobile chargers | 98W | 4 hours 17 minutes |
| TV + set-top box + 2 fans + 3 lights | 242W | 1 hour 44 minutes |
| 3 BLDC fans + 6 LED bulbs | 144W | 2 hours 55 minutes |
About 2 hours 35 minutes. The load averages 163W and the battery delivers 420Wh usable at 70% efficiency and 50% depth of discharge, so 420 / 163 = 2.6 hours.
Because 70% is an assumption, not your measurement. A battery two or three years old, a low electrolyte level, thin cabling or a charger that never completes a cycle in short grid windows all pull the effective factor down. At 55% the same setup gives 2 hours 1 minutes. Measure yours with the efficiency estimator.
A standard 600VA inverter. The sizing rule is (average load / power factor 0.8) x 1.25 safety margin, which on 163W gives 255VA and rounds up to the nearest retail tier.
No. Lead-acid tubular batteries are rated for roughly 50% depth of discharge — draining past half state of charge sulphates the plates and shortens life sharply. That is why 100Ah x 12V = 1200Wh nominal becomes 420Wh usable.
Cut the load, not the comfort. Replacing induction ceiling fans with 30W BLDC fans and any remaining CFLs with 9W LEDs typically removes 40-45W per fan and 6W per bulb. On this profile that is the difference between 2 hours 35 minutes and materially more, at a fraction of the cost of a second battery.
No. Battery Buddy is a free, brand-neutral calculator from Flocci Technologies. It shows the formula for every number so you can check it against any dealer's quote, and it needs no sign-up.
Battery Buddy is free, needs no sign-up, sells no batteries and shows every formula it uses. It is built by Flocci Technologies, an India-first AI-native software studio behind 30+ apps that share one Flocci identity.