What size inverter and battery does a medical store need?

The load this premises actually carries

A pharmacy where the refrigerated shelf and the billing system are both non-negotiable. Each appliance is counted at the minutes it genuinely runs in an hour, not at full nameplate wattage for sixty minutes — that duty-cycle step is what separates a sizing you can trust from a dealer's round number.

Why 1100VA and not something bigger

Inverters are sold in VA, not watts. Battery Buddy converts with the standard power factor of 0.8 and adds a 25% safety margin: (592.5W / 0.8) x 1.25 = 926VA, which rounds up to the 1100VA tier actually sold in Indian retail.

Oversizing is not free. A larger inverter idles at a higher no-load draw, costs more, and tempts you to add load the battery cannot support. Size the inverter to the load, then size the battery to the outage.

Why the system runs at 24V

Medium loads with improved efficiency. Typically two 12V batteries in series. Battery Buddy escalates system voltage automatically once average load passes 400W (to 24V), 800W (to 48V) and 2000W (to 96V). At 592.5W this profile sits at 24V.

Higher DC voltage carries the same power at lower current, which means less heat in the cabling and a safer install. The cost is that batteries must be added in matched series sets — 2 x 220Ah 12V batteries in series.

Battery bank and charging

Target energy is 592.5W x 6 hours = 3555Wh. Dividing by 24V x 0.7 efficiency x 0.5 depth of discharge gives 423Ah, and the nearest standard bank is 220Ah — rated for a sustained load of 560-750W.

Charge it at 22-27A, the C/10 to C/8 guideline. Under-charging leaves a lead-acid bank permanently short of full and is one of the most common reasons backup quietly halves over two years.

Note: at this bank size the honest achievable runtime on this load is about 3 hours 7 minutes, short of the 6-hour target. Either add a parallel string, move to the next voltage tier, or accept a shorter window and plan what you switch off.

The overload check nobody runs

With everything on, continuous draw is 630W. The Refrigerator (190L) spikes to about 450W at start-up, so peak demand is 1080W. A 1100VA inverter holds that with 2% headroom.

Backup target versus battery cost

Every extra hour of backup is bought with amp-hours. This is the trade-off for exactly this load.

Frequently asked questions

What size inverter is needed for a medical store?

A 1100VA inverter for a 592.5W average load. That comes from (592.5 / 0.8) x 1.25 = 926VA, rounded up to the nearest standard retail size.

What battery capacity does a medical store need for 6 hours of backup?

About 423Ah at 24V, which maps to a standard 220Ah bank — 2 x 220Ah 12V batteries in series. The energy target is 3555Wh at 70% efficiency and 50% depth of discharge.

Should this run on 12V or a higher system voltage?

24V. Medium loads with improved efficiency. Typically two 12V batteries in series. The threshold Battery Buddy uses is 400W average load for 24V, 800W for 48V and 2000W for 96V.

What charging current should the inverter provide?

22-27A, following the C/10 to C/8 guideline for a 220Ah lead-acid bank. Too little current never completes a cycle in short grid windows; too much cooks the electrolyte.

Will the inverter trip when a motor starts?

Peak demand here is 1080W — 630W continuous plus the 450W start-up surge of the Refrigerator (190L). A 1100VA inverter clears it.

Is this a brand recommendation?

No. Battery Buddy is brand-neutral and free — it returns a VA rating, an Ah figure, a system voltage and a charger current, and shows the formula behind each. Take those four numbers to any dealer and compare quotes on equal terms.