Home / Backup time / 150Ah with Full home load
A 150Ah 12V tubular battery runs 2 fans + 6 lights + TV + refrigerator + WiFi for about 1 hour 34 minutes. That load averages 404W, and the battery holds 630Wh usable once you apply 70% inverter efficiency and the 50% depth of discharge lead-acid batteries are limited to. 630Wh / 404W = 1.6 hours.
Everything the family expects to keep working — the honest worst case. Duty cycle matters here: Battery Buddy multiplies each appliance by the minutes it actually runs in an hour, so a fridge that cycles 40 minutes an hour is counted at two-thirds of its nameplate wattage instead of full blast.
| Appliance | Watts each | Qty | Minutes per hour | Average draw |
|---|---|---|---|---|
| Ceiling Fan | 70W | 2 | 60 min | 140W |
| LED Bulb | 9W | 6 | 60 min | 54W |
| LED TV (43-inch) | 100W | 1 | 60 min | 100W |
| Refrigerator (190L) | 150W | 1 | 40 min | 100W |
| WiFi Router | 10W | 1 | 60 min | 10W |
| Total average hourly load | 404W |
On paper a 150Ah 12V battery stores 150 x 12 = 1800Wh. You never get that. Lead-acid tubular plates are rated for roughly 50% depth of discharge, and the inverter loses more converting DC to AC, so the honest figure is 150 x 12 x 0.7 x 0.5 = 630Wh.
India's best-selling home inverter battery size. If you have already measured your own system with the efficiency estimator, put your real factor into the calculator — that single number moves the answer more than any other input.
At 1 hour 34 minutes this is a High Load setup — Battery Buddy flags anything under 2 hours, because a single long outage will empty the bank before the grid returns.
Runtime and capacity are two different questions. With every appliance on at once this profile draws 454W continuous, which sizes to (404W / 0.8) x 1.25 on average draw and lands on a standard 800VA inverter.
The start-up surge test is the one most calculators skip. Refrigerator (190L) spikes to about 450W for a second or two when its motor kicks in, so peak demand is 454W continuous + 450W surge = 904W. Against a 800VA inverter that is an overload — the inverter will beep and cut out.
Battery age, electrolyte level, cable thickness and terminal corrosion all show up as one thing: a lower effective efficiency. Here is the same battery and the same load across the realistic range.
| System efficiency | Usable energy | Estimated backup |
|---|---|---|
| 55% | 495Wh | 1 hour 14 minutes |
| 60% | 540Wh | 1 hour 20 minutes |
| 65% | 585Wh | 1 hour 27 minutes |
| 70% (default) | 630Wh | 1 hour 34 minutes |
| 75% | 675Wh | 1 hour 40 minutes |
| 80% | 720Wh | 1 hour 47 minutes |
Run the two-hour test on the efficiency estimator to replace this guess with your own measured factor.
If you are still choosing a battery, this is the whole shelf against exactly this load.
| Battery | Usable energy | Estimated backup | Band |
|---|---|---|---|
| 100Ah | 420Wh | 1 hour 2 minutes | High load |
| 120Ah | 504Wh | 1 hour 15 minutes | High load |
| 135Ah | 567Wh | 1 hour 24 minutes | High load |
| 150Ah (this page) | 630Wh | 1 hour 34 minutes | High load |
| 165Ah | 693Wh | 1 hour 43 minutes | High load |
| 180Ah | 756Wh | 1 hour 52 minutes | High load |
| 200Ah | 840Wh | 2 hours 5 minutes | Moderate |
| 220Ah | 924Wh | 2 hours 17 minutes | Moderate |
| 250Ah | 1050Wh | 2 hours 36 minutes | Moderate |
And this is the same 150Ah battery against every other load profile we model.
| Load profile | Average draw | Estimated backup |
|---|---|---|
| 2 ceiling fans + 3 LED bulbs | 167W | 3 hours 46 minutes |
| 1 ceiling fan + 2 LED bulbs | 88W | 7 hours 10 minutes |
| 3 ceiling fans + 5 LED bulbs | 255W | 2 hours 28 minutes |
| 2 fans + 4 lights + TV + WiFi router | 246W | 2 hours 34 minutes |
| Refrigerator + 2 fans + 4 LED bulbs | 276W | 2 hours 17 minutes |
| Laptop + WiFi router + 1 fan + 2 lights | 163W | 3 hours 52 minutes |
| 2 fans + 6 lights + TV + refrigerator + WiFi (this page) | 404W | 1 hour 34 minutes |
| Air cooler + 2 LED bulbs | 198W | 3 hours 11 minutes |
| 4 tube lights + 2 fans + billing computer | 420W | 1 hour 30 minutes |
| 1 fan + 2 lights + 2 mobile chargers | 98W | 6 hours 26 minutes |
| TV + set-top box + 2 fans + 3 lights | 242W | 2 hours 36 minutes |
| 3 BLDC fans + 6 LED bulbs | 144W | 4 hours 23 minutes |
About 1 hour 34 minutes. The load averages 404W and the battery delivers 630Wh usable at 70% efficiency and 50% depth of discharge, so 630 / 404 = 1.6 hours.
Because 70% is an assumption, not your measurement. A battery two or three years old, a low electrolyte level, thin cabling or a charger that never completes a cycle in short grid windows all pull the effective factor down. At 55% the same setup gives 1 hour 14 minutes. Measure yours with the efficiency estimator.
A standard 800VA inverter. The sizing rule is (average load / power factor 0.8) x 1.25 safety margin, which on 404W gives 631VA and rounds up to the nearest retail tier.
No. Lead-acid tubular batteries are rated for roughly 50% depth of discharge — draining past half state of charge sulphates the plates and shortens life sharply. That is why 150Ah x 12V = 1800Wh nominal becomes 630Wh usable.
Cut the load, not the comfort. Replacing induction ceiling fans with 30W BLDC fans and any remaining CFLs with 9W LEDs typically removes 40-45W per fan and 6W per bulb. On this profile that is the difference between 1 hour 34 minutes and materially more, at a fraction of the cost of a second battery.
No. Battery Buddy is a free, brand-neutral calculator from Flocci Technologies. It shows the formula for every number so you can check it against any dealer's quote, and it needs no sign-up.
Battery Buddy is free, needs no sign-up, sells no batteries and shows every formula it uses. It is built by Flocci Technologies, an India-first AI-native software studio behind 30+ apps that share one Flocci identity.